What is the safety rule regarding suspended loads and the employee? [Solved] (2022)

What is the safety rule regarding suspended loads and the employee?

Put a “10-feet rule” in place. No company employee is allowed to be within a 10-feet radius of the suspended load in case of equipment malfunction and/or an accidental drop. If a load is suspended more than 15 feet high, then increase that radius.... read more ›

How do we protect people when working around suspended loads?

Always place strong backs, slings, chains, and even forklift forks down to the ground when not in use, even when they do not carry a load. Be sure that everyone around a suspended load is wearing a hard hat. One in 5 employees killed in falling load accidents are struck by flying parts and pieces of rigging.... continue reading ›

What are suspended loads?

Definition of Suspended load:

Suspended load refers to that part of the total sediment transport which is maintained in suspension by turbulence in the flowing water for considerable periods of time without contact with the stream bed. It moves with practically the same velocity as that of the flowing water..... continue reading ›

When using a crane to suspend workers on a personnel platform the loaded platform and its rigging must not exceed?

The total load (with the platform loaded, including the hook, load line and rigging) must not exceed 50 percent of the rated capacity for the radius and configuration of the equipment, except during proof testing.... see more ›

What is crane suspended load?

A suspended load is an object that is temporarily lifted and hangs above the ground. Working or walking immediately under / close to a suspended load is unsafe as the load can fall on you. • Never cross a barrier controlling an area with a suspended load. without authorization.... view details ›

Is it safe to work under a suspended load?

Never allow more than one person to control a lift or give signals to a crane or hoist operator except to warn of a hazardous situation. Never raise the load more than necessary, or leave the load suspended in the air. Never allow anyone to work under a suspended load.... read more ›

Under what conditions is it safe to stand on a suspended load?

At a minimum, stay at least 10 feet radius from where a suspended load could fall if there was failure. If a load is suspended higher, increase the radius. Remember that a suspended load can be anything moved using such equipment as a crane, forklift, hoist or tractor bucket.... read more ›

Is a suspended load a hazard?

The dangers of working under a suspended load

If a load falls, it can quickly break and split, becoming a series of injurious and deadly projectiles. Harmful splashes, flooding, shattered bones, and injuries to the eyes, head, and soft tissues can occur.... read more ›

Can you leave a suspended load unattended?

NEVER LEAVE A SUSPENDED LOAD UNATTENDED. Do not pass a load over coworkers or allow anyone to walk under the load. Never operate a crane if you cannot see the load or the entire crane.... see more ›

Can you walk under a suspended load?

Working or walking immediately under a suspended load is unsafe as the load can fall on you. A suspended load is an object that is temporarily lifted and hangs above the ground. You should: Never walk or stand under a suspended load.... see more ›

What is the safety factor that is applied to rigging hardware used to suspend a personnel platform?

The required design factor is achieved by taking the current safety factor of 3.5 [required under section 4884(b) of these Orders] and applying the 50 percent derating of the crane capacity which is required by section 5004(d)(5) of these Orders.... read more ›

When using a crane to suspend workers on a personal platform the loaded platform and its rigging?

When using a crane to suspend workers on a personnel platform, the loaded platform and its rigging must not exceed 50% of the rated capacity for the crane. When it is difficult for an operator to determine power line clearance by visual means, an observer is not necessary.... see details ›

What must the competent person inspect before a suspended platform can be used to hoist personnel?

A competent person must inspect the crane, the suspension of the platform or basket, and rigging before each use and after each proof test. Personnel suspended from platforms or baskets must understand and use hand signals or use continuous radio communication.... see more ›

What should be done when dealing with overhead loads?

How should you move loads safely?
  1. Move crane controls smoothly. ...
  2. Follow signals only from one slinger in charge of the lift, except a stop signal.
  3. Use agreed upon signals.
  4. Make sure everyone is away from the load before hoisting. ...
  5. Make sure all slings, hooks, hardware, etc.

What safety precaution must be taken for loads being lifted near a scissor lift?

Check to see that a guardrail system is in place before working on the scissor lift. Only stand on the work platform; never stand on the guardrails. Keep work within easy reach to avoid leaning away from the scissor lift.... view details ›

What does OSHA consider a suspended load?

As stated in that letter, "The OSHA standard on overhead and gantry cranes, §1910.179, defines a load as 'The total superimposed weight on the load block or hook. ' Since below the hook devices or slings would be part of the weight on the load block or hook, these would be considered a suspended load."... continue reading ›

Can you leave a suspended load unattended?

NEVER LEAVE A SUSPENDED LOAD UNATTENDED. Do not pass a load over coworkers or allow anyone to walk under the load. Never operate a crane if you cannot see the load or the entire crane.... read more ›

Popular posts

You might also like

Latest Posts

Article information

Author: Pres. Lawanda Wiegand

Last Updated: 09/18/2022

Views: 6538

Rating: 4 / 5 (71 voted)

Reviews: 86% of readers found this page helpful

Author information

Name: Pres. Lawanda Wiegand

Birthday: 1993-01-10

Address: Suite 391 6963 Ullrich Shore, Bellefort, WI 01350-7893

Phone: +6806610432415

Job: Dynamic Manufacturing Assistant

Hobby: amateur radio, Taekwondo, Wood carving, Parkour, Skateboarding, Running, Rafting

Introduction: My name is Pres. Lawanda Wiegand, I am a inquisitive, helpful, glamorous, cheerful, open, clever, innocent person who loves writing and wants to share my knowledge and understanding with you.